What should I pay attention to in daily cleaning of home popcorn machine

As a kitchen device that enhances the family entertainment experience, the quality of daily cleaning of the home popcorn machine directly affects the performance, food safety and service life of the device. For the cleaning process of this device, a series of professional steps must be followed to ensure the efficiency and safety of the device in long-term use.

Before cleaning, users need to make adequate preparations to ensure the safety of operation and cleaning effect. First of all, be sure to clean the device after it has completely cooled down to avoid deformation or circuit failure caused by contact between high-temperature components and moisture. Before cleaning, be sure to unplug the power plug to ensure that the device is in a power-off state. For models with detachable parts, users should follow the instructions in the manual to gradually disassemble components such as the stirring paddle, pot body, and top cover. During the disassembly process, it is recommended to record the installation order and direction of each component to avoid misalignment during subsequent assembly. The selection of cleaning tools is also crucial. Food-grade silicone spatulas, soft-bristled nylon brushes, semi-dry non-woven fabrics, etc. should be used first. Tools that may damage the coating, such as steel wool or hard plastic spatulas, are strictly prohibited.

The cleaning of core components should follow a standardized process. The stirring paddle assembly is the focus of cleaning, and the charred residue on the surface of the Teflon coating needs to be carefully cleaned. It is recommended to scrape off large pieces of residue with a silicone shovel first, and then use a soft brush with warm water and neutral detergent to scrub carefully. For stubborn oil stains, you can soak it in a 5% citric acid solution for about 10 minutes before cleaning, but special attention should be paid to avoid contact between the acid solution and the metal shaft core. The inner wall of the pot should be wiped with a semi-dry non-woven cloth. For the carbide around the heating tube, it is recommended to use a special cleaning cotton swab and dip it in a small amount of edible baking soda solution for spot cleaning. The cotton swab should be kept moderately moist during operation to prevent the solution from penetrating into the circuit area. The sugar residue on the top cover and the outlet should be soaked in warm water first, and then gently scrubbed along the gap with a soft brush to avoid excessive force causing the sealing strip to fall off.

Appropriate methods should be adopted for cleaning special materials. As an important part for observing the production process, the transparent window needs to be cleaned with a special glass cleaner and microfiber cloth. Do not use detergents containing alcohol or ammonia to avoid damaging the explosion-proof coating. If there are slight scratches on the window, you can use automotive glass polish with a polishing wheel to repair it. Be careful to control the speed below 1500 rpm. The cleaning of the stainless steel shell should be carried out along the direction of the metal texture. For stubborn water stains, you can use a solution mixed with white vinegar and water in a ratio of 1:3. After treatment, rinse with clean water and wipe dry immediately. Teflon coated parts should not be scratched with sharp tools. If there is slight peeling, food-grade high-temperature repair paint can be used for local repair.

The treatment after cleaning directly affects the performance of the equipment. All removable parts must be completely dried before assembly. Hot air circulation equipment below 60°C can be used to assist in drying, but high temperature should be avoided to prevent deformation of plastic parts. During the assembly process, it is necessary to carefully check whether the sealing ring is installed in place. For rubber seals, a small amount of food-grade silicone grease can be applied to enhance the sealing. After cleaning the power interface area, use an anti-static brush to remove dust, and avoid spraying liquid detergent directly. When idle for a long time, apply food-grade mineral oil on the surface of the heating tube to prevent rust, and store the device in a dry and ventilated environment, keeping the relative humidity between 40% and 60%.